Datamax 7A300007 Rev. 2 manual Wi-Fi Communication Option, Printer Status Indicator LED Panel, Led

Wi-Fi Communication (Option)

The printer control card communicates with the Wi-Fi interface at 115.2 K Baud/sec for serial interface printers and 57.6 K for USB interface printers. To select the WiFi interface, Dip Switch # 1 or Dip Switch # 2 (See Dip Switch Settings table above) must be ON and all other Dip Switches must be OFF. Below are the factory default settings of the Wi-Fi module. For more information please refer to the 802.11g kit available on the Developer’s CD.

Settings IP address DHCP mode Ad - Hoc mode Infrastructure mode

SSID Tunnel port

Value

192.168.1.96

Disabled

Enabled

Disabled

APEX# , where # matches the printer model

23 (to send data to the 802.11g module use this port number)

Printer Status Indicator LED Panel

The table below describes the normal function of each of the Printer’s Status LEDs.

LED	Status	Condition	Function
	GREEN	Flashing	Power is ON and the printer is in RS232/USB or IRDA mode
		Steady	Communicating with host
LED # 1	BLUE	Flashing	Power is ON and the printer is in Bluetooth mode
		Steady	Transmitting/receiving
Communication
		Flashing	Power is ON and the printer is in 802.11b/g mode
	Light Blue
		Steady	Transmitting/Receiving in 802.11 mode OR
			Printing Self test in 802.11 mode
LED # 2	AMBER	Steady	Battery being charged. The LED will turn off when the battery is fully charged
Battery
		Steady	Indicates that MCR or SCR is ready to accept data
LED # 3			 Dip Switches 5 and 7 are ON – USB cable is plugged in.
			Note: If USB is unplugged, LED will flash Amber until printer is reset
Magnetic Card	GREEN		manually
		Flashing
Reader			 Serial Firmware upload
&
			Note: Firmware upload complete indicated by blue flashing LED #3
Printer Error

57