I F T H E P O W E R L I G H T I S O F F The computer is either turned off or is not receiving power.

Reseat the power cable into both the power connector on the back of the computer and the electrical outlet.

If the computer is plugged into a power strip, ensure that the power strip is plugged into an electrical outlet and that the power strip is turned on. Also bypass power protection devices, power strips, and power extension cables to verify that the computer turns on properly.

Ensure that the electrical outlet is working by testing it with another device, such as a lamp.

Ensure that the main power cable and front panel cable are securely connected to the system board (see page 64).

I F THE POWER LIGHT IS STEADY AMBER A device might be malfunctioning or incorrectly installed.

Ensure that the processor cable is securely connected to the system board (see page 64).

Remove and then reinstall the memory modules (see page 66).

Remove and then reinstall any cards (see page 68).

Remove and then reinstall the graphics card, if applicable (see page 72).

I F THE POWER LIGHT IS BLINKING AMBER The computer is receiving electrical power, but an internal power problem might exist.

Ensure that the voltage selection switch is set to match the AC power at your location (if applicable).

Ensure that the processor power cable is securely connected to the system board (see page 64).

E LIMINATE INTERFERENCE Some possible causes of interference are:

Power, keyboard, and mouse extension cables

Too many devices on a power strip

Multiple power strips connected to the same electrical outlet

Printer Problems

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTE: If you need technical assistance for your printer, contact the printer’s manufacturer.

C HECK THE PRINTER DOCUMENTATION See the printer documentation for setup and troubleshooting information.

E NSURE THAT THE PRINTER IS TURNED ON

Solving Problems

39

Page 39
Image 39
Dell 200 owner manual Printer Problems