6WHSV

To begin the configuration, perform the following steps:

1.Turn on the filer’s power switch to begin the configuration process.

The first time the filer boots, it contacts the DHCP server and requests an IP address. The DHCP server supplies the static IP address you configured it with.

2.From a client on the same network, point a web browser to http://filer-name/api

or http://filer-ip-address/api

Replace filer-name or filer-ip-address with either the name of the filer or the filer’s IP address that you set up in the DHCP server.

The Setup Wizard loads.

3.Enter the information as requested.

5HVXOWV

After you finish configuring the filer, it is on-line. The following directories exist on the filer:

/vol/vol0

/vol/vol0/home

NOTE: /vol is not a directory—it is a special virtual root path under which the filer mounts its volumes. You cannot mount /vol to view all the volumes on the filer; you must mount each filer volume separately.

If you purchased a license for the NFS protocol, /vol/vol0 is exported to the administra- tion host for root access; /vol0/home is exported to the administration host for root access and to all clients for general access. Paths such as /etc/passwd are referenced as /vol/vol0/etc/passwd.

If you purchased a license for the CIFS protocol, /vol/vol0 is shared as C$; only the system administrator with the root password has read and write access to the C$ share. The /vol/vol0/home directory is shared as HOME without access granted to anyone.

:KHUH￿WR￿*R￿)URP￿+HUH

Verify the network connections of your new filer using the procedure in "Verifying Network Connections."

Setup Wizard — Basic Configuration of the Filer3-3

Page 31
Image 31
Dell 2385P, 720N, 740N, 760N manual 6WHSV, 5HVXOWV, Khuhwr*Rurp+Huh