& + $ 3 7 ( 5
VHWXS&RPPDQG³,QWURGXFWLRQ
2YHUYLHZ
&RQILJXUDWLRQ3URFHVV
To configure a new filer for the first time, perform the following steps. Some of the procedures are optional, depending on the filer options that you purchased.
1.Set up DHCP.
If you want to use the Dynamic Host Configuration Protocol (DHCP) to configure the filer’s onboard interface (e0), follow the instructions in "Using DHCP With the Filer."
Using DHCP to assign an IP address to a filer enables you to use a Telnet client to complete the
2.Add the filer to a Windows NT domain.
If you purchased a license for the CIFS protocol for your filer and you plan to add the filer to a Windows NT domain, see "Adding the Filer to a Windows NT Domain" in Appendix C.
3.Configure the filer.
Configure your filer according to the instructions in "Configuring the Filer."
4.Verify the filer’s network connections.
Verify that the filer is communicating on the network by following the instructions in "Verifying Network Connections."
5.Configure HTTP service.
If you purchased a license for the HTTP protocol for your filer, configure the HTTP options as described in Chapter 6, "Configuring HTTP on the Filer."
6.Set up passwd and group files.
setup Command — Introduction
