Clearing Cmos Settings, 177

4Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.

5Wait for approximately five seconds to clear the password.

6Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3 to enable the password feature.

7Replace the computer cover (see "Replacing the Computer Cover" on page 162).

NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.

8Connect your computer and devices to electrical outlets, and turn them on.

Clearing CMOS Settings

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

1Follow the procedures in "Before You Begin" on page 99.

NOTE: The computer must be disconnected from the electrical outlet to clear the CMOS setting.

2Remove the computer cover (see "Removing the Computer Cover" on page 101).

3Reset the current CMOS settings:

a Locate the 3-pin CMOS jumper (CLEAR CMOS) on the system board (see "System Board Components" on page 105).

b Remove the jumper plug from the CMOS jumper (CLEAR CMOS) pins 2 and 3.

c Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1 and 2 and wait approximately five seconds.

d Remove the jumper plug and replace it on the CMOS jumper (CLEAR CMOS) pins 2 and 3.

4Replace the computer cover (see "Replacing the Computer Cover" on page 162).

Appendix