Dell E19S Installing The Integrated Storage Controller, Storage connector on the system board

Figure 37. Removing and Installing the Integrated Storage Controller
1.	storage connector on the system board	4.	storage-controller card holder
2.	touch-points (2)	5.	release levers (2)

3.storage-controller card

Installing The Integrated Storage Controller

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2.Open the system.

3.Align one end of the card with the card holder on the system board.

4.Lower the other end of the card and align the holes on the card with the locating posts of the extractors on the system board.

5.Press the card down at the corners until it is fully seated.

When the card is fully seated, the plastic standoff tab snaps over the edge of the holder.

72