Dell E19S, R520 owner manual Removing The iDRAC Ports Card

Removing The iDRAC Ports Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2.Open the system.

3.Disconnect any cables connected to the iDRAC Ports card.

4.Lift the expansion-card latch

5.Remove the iDRAC Ports card.

6.If installed, remove the expansion card from slot 1 of expansion-card riser 1.

7.Supporting the expansion-card riser, hold the iDRAC Ports card by its edges and remove it from the iDRAC Ports card connector on the riser.

8.If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the expansion-card latch.

NOTE: You must install a filler bracket over an empty expansion slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.

9.Close the system.

10.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

66