support.dell.com Cluster Data Sheets B-3
Cluster Data Sheets
The data sheets on the following pages are provided for the system installer to record
applicable information about the PowerEdge Cluster FE100/FL100 Datacenter config-
uration. The data sheets are for installing Windows 2000 Datacenter Server clusters.
Make a copy of the appropriate data sheet to use for the installation or upgrade.
Complete the requested information on the sheet and have the completed sheet
available if you need to call Dell for technical assistance.

Dell PowerEdge Cluster FE100/FL100 Installer Data Sheet and Checklist for a

Complete Installation on Windows 2000 Datacenter Server
Instructions: Before configuring the systems for clustering, use this checklist to gather information and
prepare your systems for a successful installation. This data sheet assumes you are installing the server
cluster for the first time.
Ensure that all equipment is present and p roperly cabled and that you know how to install Windows 2000
Datacenter Server. Make sure each of the procedures listed below is performed correctly.
Pre-Installation Settings
GConfirm that both nodes and the storage system meet the PowerEdge Cluster FE100/FL100 minimum
configuration requirements.
GPlace NICs that support hot-plug peripheral component interconnect (HPPCI) in PCI slots that support
HPPCI, if available and if supported for the configuration.
GCable the system hardware for clustering.
Configure Storage Subsystem Components
GConfigure and initialize the shared RAID volumes.