Removing and Installing Parts 135
3
Remove the drive panel (see "Removing the Drive Panel" on page124).
4
Remove the shoulder screws from the inside of the drive-panel insert and
attach the screws to the new drive (see "Removing the Drive-Panel Insert"
on page125).
5
Turn the FlexBay knob on the cage at 90 degrees, in the anti-clockwise
direction.
NOTICE: Ensure the FlexBay knob is turned in the anticlockwise direction. Failure
to heed can result in the knob being broken.
NOTE: Turning the FlexBay knob once opens up the drive space to
accommodate a larger device like a hard drive. The knob at this stage is in a
horizontal position.
6
Pull the sliding plate lever down and hold in place.
7
Slide the hard drive into the flex bay drive until the sliding plate clicks into
place and the drive snaps into position.
8
Attach the power and hard drive cables to the hard drive.
9
Replace the computer cover (see "Replacing the Computer Cover" on
page172).
Removing a Hard Drive From the FlexBay1hard drive 2sliding plate lever
2
1
book.book Page 135 Tuesday, November 27, 2007 10:29 AM