Back to Contents Page

Microprocessor Thermal-Cooling Assembly

Dell™ Inspiron™ i1200 and i2200 Service Manual

Removing the Cooling Fan

Installing the Cooling Fan

Removing the Microprocessor Thermal-Cooling Assembly

Installing the Microprocessor Thermal-Cooling Assembly

Removing the Cooling Fan

CAUTION: Before performing the following procedures, read the safety instructions in the Product Information Guide.

To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

1.Follow the instructions in "Before Working Inside Your Computer."

2.Remove the keyboard.

3.Disconnect the display ground wire from the EMI shield by unscrewing the captive screw.

1captive screw

2display ground wire

4.Remove the four M2.5 x 5-mm screws (labeled "M2.5x5") that secure the EMI shield to the system board.

5.Pull the EMI shield out of the computer baseby rotating the front upwards then lifting to release the retention tabs from the retention-tab slots.

Page 31
Image 31
Dell I1200, I2200 manual Microprocessor Thermal-Cooling Assembly, Removing the Cooling Fan