92 Adding Parts
www.dell.com | support.dell.com
7Pull the two front-panel tabs towards you, and then push out the front-panel insert.
8Ensure that the jumper setting on the new drive is set for "cable select" (see the
documentation that came with the drive for information).
9Remove two extra alignment screws, shown in the illustration on page 93, from the
front of the computer and insert them into the drive.
NOTE: Some computers come with only two extra alignment screws; others come with four. You
only need two alignment screws for this procedure.
tabs (2)
insert
drive
alignment screws (2)
J2936bk0.book Page 92 Tuesday, September 2, 2003 3:06 PM