Status Display Board

top assembly

 

 

infrared

 

 

device

 

 

connector

speaker

 

 

connector (2)

S7

status-

 

 

 

(screws S7–S9

 

display

are 6 mm)

S8

board

 

S9

connector

status display

board

6 mm

Figure 4-28. Status Display Board Removal

To remove the status display board, follow these steps:

1.Remove the top assembly.

See “Top Assembly” found earlier in this section.

2.Remove status-display board screws S7, S8, and S9.

3.Disconnect the two speaker connectors and the infrared device connec- tor from the status display board.

4.Disconnect the status display board connector from the main board.

The connector wire assembly is held in place by a metal hook located on the I/O bracket.

5.Remove the status display board from the top assembly.

Removing and Replacing Parts 4-35

Page 71
Image 71
Dell LM P-133ST manual Status Display Board, Remove the status display board from the top assembly