Dell MD3200i, MD3220i Stopping a Virtual Disk Copy

Configuration: Premium Feature—Virtual Disk Copy 171
• Before the virtual disk copy begins
• While the virtual disk copy has a status of In Progress
• When you re-create a virtual disk copy
To set copy priority:
1
In the AMW, select Virtual Disk  Copy  Copy Manager .
The
Copy Manager window is displayed.
2 In the table, select one or more copy pairs.
3 Select Change  Copy Priority .
The
Change Copy Priority window is displayed.
4 In the Copy priority area, select the appropriate copy priority, depending
on your system performance needs.
NOTE: There are five copy priority rates available: lowest, low, medium, high,
and highest. If the copy priority is set at the lowest rate, I/O activity is
prioritized, and the virtual disk copy takes longer.
Stopping a Virtual Disk Copy
You can stop a virtual disk copy operation that has an In Progress status, a
Pending status, or a Failed status. Stopping a virtual disk copy that has a
Failed status clears the Needs Attention status displayed for the storage array.
Keep these guidelines in mind when you stop a virtual disk copy:
• To use this option, select only one copy pair in the Copy Manager.
• When the virtual disk copy is stopped, all of the mapped hosts have write
access to the source virtual disk. If data is written to the source virtual disk,
the data on the target virtual disk no longer matches the data on the
source virtual disk.
To stop a virtual disk copy, complete the following steps:
1
In the AMW, select Virtual Disk  Copy  Copy Manager .
The
Copy Manager window is displayed.
2 Select the copy pair in the table.
3 Select Copy  Stop .
4 Click Yes .
book.book Page 171 Wednesday, May 26, 2010 2:14 PM