Installing the Heat Sink, Removing the System Fan | Dell W07B

Installing the Heat Sink

1.Place the heat sink on the computer.

2.Tighten the screws to secure the heat sink to the computer.

3.Install:

a)system board cover

b)back cover

c)VESA stand

d)stand cover

4.Follow the procedures in After Working Inside Your Computer.

Removing the System Fan

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a)stand cover

b)VESA stand

c)back cover

d)system board cover

3.Disconnect and release the system-fan cable from the system board. Remove the screws that secure the system fan to the computer and remove it from the computer.

Installing the System Fan

1.Place the system fan on the computer.

2.Guide the system-fan cable through its tab on the computer and connect the cable to the system board.

3.Install:

a)system board cover

b)back cover

c)VESA stand

d)stand cover

20

Image 20

Dell W07B owner manual Installing the Heat Sink, Removing the System Fan, Installing the System Fan

Contents

Regulatory Model W07B Regulatory Type W07B001 Dell Inc. All Rights Reserved Contents System Setup DiagnosticsTroubleshooting Your Computer Technical Specifications Contacting Dell Working on Your Computer Before Working Inside Your Computer Click Shut Down Recommended ToolsTurning Off Your Computer After Working Inside Your Computer Important InformationPage Removing and Installing Components System Overview Removing the Vesa Stand Installing the Stand CoverRemoving the Stand Cover Installing the Vesa Stand Removing the Back Cover Remove the back cover from the computer Installing the Back Cover Removing the Optical Disk Drive Remove Installing the Optical Disk DriveRemoving the Control Board Installing the Control Board Removing the Wireless Local Area Network Wlan Card Installing the Wlan Card Removing the Memory Installing the Memory Removing the System Board Cover Installing the System Board Cover Removing the Coin-Cell Battery Installing the Coin-Cell Battery Removing the Heat Sink Removing the System Fan Installing the Heat SinkInstalling the System Fan Removing the Processor Installing the ProcessorRemoving the Intrusion Switch Installing the Intrusion Switch Removing the Speakers Installing the Speakers Removing the Power Switch Installing the Power Switch Removing the Hard DrivePage Installing the Hard Drive Removing the System BoardPage Page Page Serial port connector System Board Components Installing the System Board Removing the Display BracketPage Page Installing the Display Bracket Vesa stand Stand cover Installing the CameraRemoving the Camera Removing the Serial Port Installing the Serial Port Page System Setup Boot SequenceFollowing table displays the system setup navigation keys Navigation Keys System Setup Options Advanced Boot Options Exit Exits and starts the computerNot selected. The other options are Date/Time Reporting Technology specification Enable Smart Reporting This option is disabled by defaultUSB Configuration Enable Audio option is selected With a system password and/or HDD password System PasswordPrimary password Internal HDD-0 Password Disabled Enabled Keys will restore to default settings All Enabled by defaultOption is enabled by default Enabled by default OptionDescription Bluetooth Verbose Mode 255.255.255.255 Updating the Bios System and Setup PasswordRe-start the computer Computer Press Y to save the changes. The computer reboots Diagnostics Enhanced Pre-Boot System Assessment ePSA DiagnosticsPage Troubleshooting Your Computer Important Information Diagnostic Power LED Codes Error Messages Beep Codes Message Page Technical Specifications FeatureSpecification Feature Specification Adapter bracket Control keysMini PCI Express One Ports and Connectors Feature Specification Non-Touch Tilt Degrees to 30 degreesKg 8.63 kg 17.94 lb 19.02 lb Reading data from or writing data to the hard drive Power supply diagnostic light Back of the computer and the electrical outletPage Contacting Dell