DeLonghi EAM3200 Cleaning the Drip Tray and Used Water Tray, Cleaning the Coffee Spout

Figure 23

Figure 21

Figure 22

EAM3200_manual_final 5/19/04 11:50 AM Page 23

23

•Remove the water tank by moving the milk frother to the outside of the machine.

•Wash the tank with warm water and mild detergent. Rinse and dry thoroughly.

•Replace the water tank.

15.3 Cleaning the Drip Tray and Used Water Tray:

•The drip tray is fitted with a red level indicator, showing the level of the water inside.

•When the indicator is visible, the drip tray and used water tray must be emptied and cleaned.

•Wash the drip tray and used water tray with

warm water and mild detergent. Rinse and dry thoroughly.

• Replace the used water tray and drip tray.

15.4 Cleaning the Coffee Spout:

• Check that the holes in the coffee spout are not blocked.

• To clean them, carefully scrape the dry coffee residues from the coffee spout with a needle (Figure 21).

15.5 Cleaning the Milk Frother:

Note: The milk frother must be cleaned after each use. Deactivate the steam function before

cleaning. Please proceed as follows (the machine must be on during the cleaning of the milk frother):

•Release a little steam for a few seconds by turning the steam control dial counter-clockwise until it stops. (Figure 7).

•With this operation, the steam nozzle discharges any milk that may have been left inside. IMPORTANT: For health reasons, this operation should always be performed to prevent previously

used milk from remaining inside the milk frother.

• With one hand, hold the milk frother handle and with the other hand unscrew the milk frother by

turning it clockwise and then pull it down. (Figure 22)

• Carefully wash the milk frother and steam nozzle

in warm water.

• Check that the two holes (indicated by the arrows in Figure 23) are not clogged. If necessary,