DeLonghi EAM3200 instruction manual Cleaning the Brewing System

Figure 25

Figure 24

EAM3200_manual_final 5/19/04 11:50 AM Page 24

24

clean them using a needle or pin.

•Replace the steam nozzle by inserting it and vigorously turning it upwards into the steam spout.

•Replace the milk frother by pushing it upwards and turning it counter-clockwise.

15.6 Cleaning the Brewing System:

Warning: The brewing system can only be removed when the machine is off. Attempting to remove the brewing system with the machine on will risk causing damage.

Note: The brewing system must be cleaned very frequently (depending on use) to prevent it from filling with coffee deposits (that may lead to malfunctions). To clean it, proceed as follows:

•Make sure the machine is turned off, but do not unplug it. Wait for all indicator lights to go off.

•Open the service door (Figure 24)

•Remove the drip tray and used coffee container and clean

them (as noted above)

• Press the two red

release buttons on the brewing system (Figure 25) and pull it

out.

• Wash the brewing

system under running

water, without using detergents. Never place the brewing system in

the dishwasher.

• Carefully clean the inside of the machine by scraping it with a plastic or wooden fork (Figure 26) and then pick up all the residues using a vacuum

cleaner (Figure 27)

Figure 26

• Replace the brewing system by sliding it onto the

supports and the pin at the bottom. Then push the PUSH symbol fully in until you hear a click.

Check that the two red buttons have opened back out, otherwise the service door cannot close properly.