Positive stops are provided to rapidly position the saw blade at 90 and 45 degrees to the table. Refer to the section of this manual titled “ADJUSTING 90 AND 45 DEGREE BEVEL STOPS.” The bevel angle of the cutting arm is determined by the position of the pointer
(C) Fig. 42, on scale (D).
In addition, an indicator is provided on the bevel scale at the 33.9 degree bevel angle for cutting crown moulding. Refer to the “CUTTING CROWN MOULDING” section of this manual.
C
D
Fig. 42
ADJUSTING SLIDING FIT BETWEEN
TRUNNION AND BEVEL BRACKET
D 
C
AB
Fig. 43
When it becomes necessary to adjust the sliding fit between the trunnion (A) Fig. 43, and bevel bracket (B), proceed as follows: Tighten adjusting nut (C) until snug sliding fit is obtained. NOTE: This adjustment must be made with the bevel lock handle (D) loose. This adjustment should not be too tight that it restricts the sliding movement or too loose that it affects the accuracy of the saw cut.
15
