MOVING CUTTINGHEAD TO THE REAR POSITION
(For models 36-240 and 36-250)
1.MAKE CERTAIN THE TOOL IS DISCONNECTED FROM THE POWER SOURCE.
2.Carefully remove cable tie (A) Fig. 12, which is holding the cuttinghead in the down position.
3.Find the bevel locking knob with flat washer (B) Fig. 13, supplied with the machine. Thread bevel locking knob and flat washer into hole (C) Fig. 13. Assembled bevel locking knob is shown in (B) Fig. 14. Firmly tighten locking knob.
4.To move the cuttinghead (D) Fig. 15, to the rear position, loosen lock knob (E) and push cuttinghead (D) to the rear position.Then tighten lock knob (E) Fig. 16.
5.Fig. 16, illustrates the cuttinghead locked in the rear position.
E
D
Fig. 15
A
Fig. 12
C
B
Fig. 13
B
Fig. 14
E
Fig. 16
8
