13
2. Fig. 28, illustrates the motor cord connected to the
switch assembly.
CONNECTING MOTOR CORDTO SWITCH ASSEMBLY
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Insert the pronged motor plug (A) Fig. 27, into the
female receptacle (B) of switch-to-motor cord (C).
8. IMMEDIATELYAFTER ASSEMBLING
THE BELT, RAISETHE SAW BLADE TO ITS MAXIMUM
HEIGHT AND TILTTHE SAW BLADE TO 45 DEGREES.
USINGA STRAIGHT EDGE (L) FIG. 25, CHECK TO SEEIF
THEMOTOR END (J) FIG. 25, IS BELOW THE TOP OF THE
TABLESURFACE (K). IF THE MOTOR END (J) ISABOVE
THETOP OFTHE TABLESURFACE, THE MOTOR MUST
BEMOVED TO THE LEFT UNTIL YOU ARE CERTAIN THE
TOP (J) OF THE MOTOR IS BELOW THE TOP OF THE
TABLESURFACE. THEN RE-ALIGN THEMOTOR PULLEY
TOTHE ARBOR PULLEY.
10. Align the hole in the outer cover (D) Fig. 26, with the
1/4-20x1-1/2" hex head screw (D) Fig. 23. Place the
outer cover (E) Fig. 23, onto the hex head screw. Place
a 1/4" external tooth lockwasher onto the hex head
screw, thread a 1/4-20 wing nut onto the hex head
screw, and tighten securely. Make certain
the outer cover does not interfere with the drive belt and
the motor pulley.
9. Place a 1/4" flat washer onto the 1/4-20x1-1/2" hex
head screw (D) Fig. 23. Place the spacer (F) Fig. 23,
onto the 1/4-20x1-1/2" hex head screw (D) Fig. 23, and
thread a 1/4-20 hex nut (E) Fig. 23, onto the hex head
screw.
Fig. 25
Fig. 26
D
E
Fig. 27
A
B
C
Fig. 28
KLJ