ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

STAND LEGS

1.Assemble the longer bottom bracket (A) Fig. 6, to the inside of two table legs (B) as shown. Align the holes in the longer bottom bracket (A) Fig. 6, with the holes in the table legs (B). Insert a 5/16-18x5/8" carriage head bolt through the hole in the table leg (B) and the hole in the longer bottom bracket (B), place a 5/16" flat washer onto the carriage head bolt, place a 5/16" lockwasher onto the carriage head bolt, thread a 5/16-18 hex nut onto the carriage head bolt. NOTE: Only snug-up stand mounting hardware at this time. Repeat this process for the three remaining holes in the larger bottom bracket.

2.Assemble the other stand bracket (A) Fig. 6, to the remaining two table legs (B) in the same manner.

3.Assemble the two shorter stand brackets (D) Fig. 7, to the leg assemblies (B) in the same manner as the longer bottom bracket was assembled.

4.Assemble a rubber foot (E) Fig. 7, to the bottom of each leg as shown.

STAND TO SAW

TO PREVENT PERSONAL INJURY OR DAMAGE TO THE MACHINE, WE SUGGEST THAT THE STAND BE MOUNTED TO THE SAW AS FOLLOWS:

1.Place the saw upside down on a sturdy work bench

or floor as shown in Fig. 8. TO PROTECT

THE TABLE TOP, PLACE SOMETHING BETWEEN THE TABLE TOP AND THE WORK BENCH OR FLOOR, SUCH AS A PIECE OF CARDBOARD, CARPET ETC. NOTE: Make certain the shorter stand brackets (D) Fig. 8, are at the front and rear of the saw as shown.

2.Align the eight holes in the bottom of the saw cabinet with the eight holes in stand legs. Place a 5/16" flat washer onto a 5/16-18x5/8" hex head screw. Insert the hex head screw through the hole in the saw cabinet and the hole in the stand leg. Place a 5/16" flat washer onto the hex head screw, place a 5/16" lockwasher onto the hex head screw, thread a 5/16-18 hex nut onto the hex head screw. NOTE: Only snug-up stand mounting hardware at this time. Repeat this process for the five remaining holes in the saw cabinet and the stand legs.

3.Assemble bracket (H) Fig. 9, to the inside of front leg assembly (D) as shown. Align holes in bracket (H) with holes in front leg assembly (D). Place a 5/16" flat washer onto a 5/16-18x5/8" hex head screw. Insert the hex head screw through the hole in the saw cabinet, stand leg, and bracket (H). Place a 5/16" flat washer onto the hex head screw, place a 5/16" lockwasher onto the hex head screw, thread a 5/16-18 hex nut onto the hex head screw. NOTE: Only snug-up stand mounting hardware at this time.

B

B

A

Fig. 6

B

D

B

D

E

Fig. 7

Fig. 8

H

DD

Fig. 9

8

Page 8
Image 8
Delta 36-650 instruction manual Assembly, Stand Legs, Stand to SAW