10.Using a straight edge, check to see if the saw blade is aligned with the rear of the splitter (G), as shown in Fig. 37. If alignment is necessary, loosen the screws (A) Fig. 37, align splitter (G) with the saw blade, and tighten two screws (A).
11. Lower saw blade and install table insert (P) Fig. 38,
in the saw table as shown. 
THE TABLE
INSERT SHOULD BE LEVEL WITH THE TABLE SURFACE. IF AN ADJUSTMENT IS NECESSARY, SEE
THE SECTION “ADJUSTING TABLE INSERT”.
When installing the table insert, always make certain to hold on to the blade guard (L). The insert will automatically release the holding action on the splitter and lower the blade guard when it is installed in the table opening.
EXTENSION WINGS
1. Assemble extension wing (A) Fig. 39, to the saw |
table. Align the three holes in the extension wing with the |
three holes in the side of the saw table. Place a 7/16" |
lockwasher (C) Fig. 39, onto a |
screw (B), place a 7/16" flat washer (D) onto the hex |
head screw. Insert the screw through the hole in the |
extension wing and thread the screw into the tapped |
G
A
Fig. 37
L
P
Fig. 38
D 
C 
D B
hole in the side of the saw table. Repeat this process for |
the two remaining holes in the extension wing and the |
saw table. |
A
C
2. | With a straight edge (E) Fig. 39, make certain the |
extension wing (A) is level with the saw table before | |
tightening three screws (B). | |
3. | Assemble the other extension wing to the opposite |
end of the saw table in the same manner. | |
Fig. 39
16
