Pushstick, Constructing a Push Stick | Delta 36-650 guide

CONSTRUCTING A PUSH STICK

When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily be made from scrap material by following the pattern shown.

PUSHSTICK	MAKEFROM1/2"OR3/4" WOODORTHICKNESS LESSTHANWIDTHOF MAT’L.TOBECUT		NOTCHTOHELP PREVENTHAND FROMSLIPPING
	CUTOFFHERETO PUSH1/4"WOOD	CUTOFFHERETO PUSH1/2"WOOD	1/2"SQUARES

29

Image 29

Delta 36-650 instruction manual Pushstick, Constructing a Push Stick

Contents

Professional Table Saw General Safety Rules Safety Guidelines / Definitions Additional Safety Rules for Table Saws Grounding Instructions Power ConnectionsMotor Specifications Extension Cords Unpacking and Cleaning Fence Parts Professional Table SAW Parts Hardware Stand Parts Stand to SAW AssemblyStand Legs Blade Tilting and Raising Handwheel Recommended Motor for Your SAW Installing Switch Motor Cord Motor and Motor Mounting Plate to SAW Motor to Motor Mounting Plate Motor PULLEY, Pulley GUARD, and Drive Belt Illustrates the motor cord connected to the switch assembly Connecting Motor Cord to Switch Assembly Blade Guard and Splitter Assembly Page Extension Wings Guide Rails Switch Assembly RIP Fence to Guide Rails Starting Stopping SAW Operating Controls and AdjustmentsLocking Switch OFF Position Tilting the Blade Raising and Lowering the Blade RIP Fence Operation and Adjustments Miter Gage Operation and Adjustment Adjusting Table Insert MaintenanceChanging the SAW Blade Overload Protection CROSS-CUTTING Operations Ripping Using Accessory Moulding Cutterhead Always Install Blade Guard After Operation is Compete Using Accessory Dado Head Constructing a Featherboard Using Auxiliary Wood Facing on RIP Fence Constructing a Push Stick Pushstick PARTS, Service or Warranty Assistance AccessoriesPage Canadian PORTER-CABLE Delta Service Centers