Apollo 150 III, 120 III user manual HDD Module Assembly, HDD Installation

User Manual version 2305

5.6. HDD Module Assembly

The APOLLO provides enough space to build in a 3.5” hard disk drive in the system compartment. The following steps show the way to install an internal hard disk drive.

1.Make the chassis lower side near you. Now, from your point of view, the 3.5" HDD module is to be installed to the right upper side of the system compartment.

2.Refer to Figure 5-4. Fix the hard disk drive (1) to the HDD bracket (3) with one FTS 3*5 screw.

3.Connect the one end of the 40-pin IDE cable (2) to hard disk drive.

4.There are two clips at the bottom of the compartment used to hold the HDD module to the system compartment. Insert the HDD module to the compartment and clip it into place. Fix the HDD module to the chassis with one 3*5 FMS screw outside of the right upper side of the chassis.

5.Make sure the other end of the 40-pin IDE cable is connected to the motherboard IDE 1 connector.

HDD ²Õ«~

HDD

HDD CABLE 220mm

HDD ¬[

FIGURE 5-4: HDD INSTALLATION

APOLLO 120/150 III 5-59