User Manual version 2305
APOLLO 150
1.Refer to Figure 5-9. The standard LCD used in APOLLO 150 is either 15.1” TTL LG 151X2 or 15” LVDS Chi Mei M150X3-L01 or their equivalent. The assembly of TTL LCD differs from that of the LVDS LCD.
2.Fix the LCD panel (1) to the LCD holder (9) with four PMS 3*8 screws.
3.For the TTL LCD, LM151X2 or its equivalent, the LCD cable (2) is a DF9-41S to 2*25-pin cable with around 35 cm in its length. Insert the 41-pin end into the opening at the rear side of the LCD holder and have it firmly plugged to the 41-pin connector at the rear side of the LCD panel. The other end is for later connection to the LCD1 on the motherboard.
4.For the LVDS LCD, M150X3-L01 or its equivalent, as the motherboard’s display is a TTL controller, to connect the onboard LCD controller to the LVDS LCD, an LVDS transceiver board is needed.
5.The APOLLO 150’s LVDS transceiver board is to be fixed at the system chassis between the touch controller and HDD.
6.The LCD cable for the LVDS LCD is a DF14-20 to DF14-20 cable with around 35 cm in its length. Connect one end to the connector located at the rear side of the LCD panel with the other end going through the opening at the rear side of the LCD holder for later connection to the LVDS1 on the LVDS board.
7.There is a 2*25-pin to 2*25-pin LVDS cable. Plug one end to the LCD1 on the LVDS board with the other end connected to the 2*25-pin header connector, LCD1 on the motherboard.
8.Attach the insulator (6) to the invertor (7).
9.The invertor cable (8) for APOLLO 150 is a 7-pin to 4-pin cable with wafer connectors at both sides. Connect the 7-pin end to the invertor first. The other end is for later connection to the INV1 on the motherboard.
