Apollo 120 III, 150 III user manual Apollo 120/150

User Manual version 2305

After finishing the LCD module installation, the module is to be assembled to the front bezel module, then to the chassis with the motherboard and touch controller already on.

1.Use special air blower to blow any dust between the LCD and touchscreen before the two modules are assembled together. Retain the LCD module and the front bezel module together with 8 FMS 3*6 screws.

2.Install the whole front bezel module with LCD already on to the system chassis with the motherboard, touchscreen controller and HDD module already on.

3.The LCD cable is already at the rear side of the LCD holder through the cutout. Make sure the other end is to go through the rectangle opening at the rear side of the system chassis and have it connected to LCD connector, LCD1 on the motherboard.

SPECIAL ATTENTION NEEDS TO BE PAID WHEN PLUGGING THE LVDS OR LCD CABLE TO THE LCD HEADER CONNECTOR ON THE MOTHERBOARD. MAKE SURE PIN 1 OF THE ONBOARD LCD CONNECTOR MATCH PIN 1 OF THE CABLE. ANY WRONG PLUGGING OR SHIFTED PLUGGING WILL DAMAGE THE LCD PANEL OR LEAD TO MAL-FUNCTION.

4.The touchscreen 5-pin flat cable should go through the rectangle opening at the left side of the LCD holder, then get into the chassis from the oval-shape cutout at the left side of the chassis. Connect this cable to the touchcreen controller. Connect the other end of the touch power cable to the onboard PWR 1.

5.For APOLLO 150, the invertor now is to be fixed to the left outward side of the chassis and have the invertor cable go into the chassis through the cutout. Connect the other end of the invertor cable to the motherboard’s INV1.

6.Connect the other end of the IR/LED cable to the IR/LED board.

5-66 APOLLO 120/150 III