Apollo 120 III, 150 III user manual LCD Module Assembly, Apollo

User Manual version 2305

5.8. LCD Module Assembly

Figure 5-8 and 5-9 illustrate the way to assemble the APOLLO’s LCD module.

The LCD does not fix to the main system directly. Rather, it is to be fixed to a LCD holder, then to the main system. The assembly of APOLLO 120 LCD module slightly differs from that of APOLLO 150.

APOLLO 120

1.Refer to Figure 5-8. There are two LCD brackets (2) & (3) used to fix to the LCD panel (1) to the LCD holder (11) from the up & down sides.

2.Fix the LCD panel to the LCD holder with four PMS 3*8 screws.

3.The standard LCD used in APOLLO 120 is SANYO MXS121022010 or its equivalent. It is a TTL interface LCD. The LCD cable (4) is a DF9-41S to 2*25-pin cable with around 35 cm in its length. Insert the 41-pin end into the opening at the rear side of the LCD holder and have it firmly plugged to the 41-pin connector at the rear side of the LCD panel.

4.Attach the insulator (10) to the invertor (9).

5.The invertor cable (8) is a 4-pin to 4-pin cable with wafer connectors at both sides. Connect the one end to invertor first. The other end is for later connection to the INV1 on the motherboard.

6.Connect the pink-white high voltage wires from the LCD to the invertor.

7.The invertor module is to be fixed at the right middle side of the LCD holder with the up side down.

8.For APOLLO 120, the IR/LED board (2) is to be fixed to the lower side of the LCD holder.

9.The two speakers are to be fixed to the right and left sides of the IR/LED board. The speaker wires are to be connected to the 2-pin header on the IR/LED board.

5-62 APOLLO 120/150 III