Delta 36-812, 34-814, 34-806 Assembling LVC Starter BOX to Cabinet, Assembling LVC ON/OFF Switch

ASSEMBLING LVC STARTER	A
BOX TO CABINET

If you purchased the machine with magnetic push button electrical controls, the saw is shipped with the starter box completely wired to the switch and motor. However, the starter box must be mounted to the saw cabinet. To assemble the starter box (A) Fig. 7, to the saw cabinet, proceed as follows:

1.Place a 1/4" lockwasher onto a 1/4-20x1/2" hex head screw, place a 1/4" flat washer onto hex head screw. From the inside rear of the saw cabinet, insert the 1/4-20 x 1/2" hex head screw into the hole (B) Fig. 7, in the cabinet. Repeat this process for the two remaining screws.

2.Line up the three tapped holes (C) Fig. 7, in the starter box with the screws and secure the starter box (A), to the saw cabinet.

3.Figure 8 illustrates the starter box (A) assembled to the saw cabinet.

ASSEMBLING LVC ON/OFF

SWITCH

1.Locate the LVC switch and hardware that was removed in the section “ASSEMBLING EXTENSION

WING.”

2.Mount the switch bracket (C) Fig. 10, to the inside of through hole D) on the left front edge of the extension wing with the hardware that was removed.

NOTE: If you have a GPE switch see “ASSEMBLING GPE ON/OFF Switch” instructions.

B

C

Fig. 7

A

Fig. 8

Fig. 9

D

C

A

Fig. 10

8