Denon ADV-700 manual Setting the speaker distance, Preparations

FINISH: ENTER BUTTON

ENGLISH

[2] Setting the speaker distance

•Input the distances from the listening position to the speakers and set the surround delay time.

•The default settings below are set upon shipment from the factory.

Preparations:

Measure the distances from the listening position to the speakers (L1 to L3 on the diagram at the right).

FL	Center		FR	L1: Distance from center speaker to
				listening position
				L2: Distance from front speakers to
L2		L1		listening position
				L3: Distance from surround speaker to
			Listening	listening position
			position
	L3
SL			SR

1		To perform these operations from places other than the
		system setting change menu, see page 26.
	2	At the SYSTEM SETUP MENU select “DELAY TIME”.

ENTER

Remote control unit Remote control unit

•Switch to the DELAY TIME screen.

		DELAY TIME		B
	S E T T H E D I S T A N C E T O E A C H S P E A K E R S
U N I T		METERS	F E E T
DEFAULT
FRONT&SW		9 f t
CENTER		8 f t
SURROUND		7 f t
SELECT :		FINISH: ENTER BUTTON

•Use the and cursor buttons to select the distance unit, “METERS” or “FEET”.

Press the cursor button to proceed to the next step if you do not wish to change this.

3	When “YES” is selected for “DEFAULT”, the delay times for
	the various speakers are set to the default values.

BYES: FRONT & SW / 9ft CENTER / 8ft SURROUND / 7ft

BNO: The current settings are used.

4	Select the speaker to be set using the		and	cursor
	buttons, then setting the distance between the speakers and
	the listening position using the	and	cursor buttons.

•Set the distance between the center speaker and listening position. The distance changes in units of 1 foot (0.1 meters) each time the button is pressed. Select the value closest to the measured distance.

	DELAY TIME		B
S E T T H E D I S T A N C E T O E A C H S P E A K E R S
U N I T		METERS F E E T
DEFAULT
FRONT&SW		9 f t
CENTER		8 f t
SURROUND		7 f t

SELECT :

The difference of the distances set for the different speakers must be no greater than 10 ft (3.0 m).

If an inapplicable distance is set, “CAUTION: INVALID DISTANCE” is displayed. Change the speaker position and reset.

5	Enter the setting.	ENTER
	• The SYSTEM SETUP MENU reappears.

Remote control unit

28