Denon AVR-1909 Error Messages, Step 5 : Store

Step 5 : Store

FMenu screen F q

Auto Setup	w
Audyssey MultEQ	Auto Setup
Step5:Store
	Audyssey MultEQ
Please select “Store”
	Step5:Store
to store measurement
	Storing
values.
	Please wait...

Store

Cancel

The auto setup measurement results are stored in the AVR-1909.

qPress u to select “Store 0”, then press o.

•“Storing Please wait...” is displayed on the on-screen display while the results are being stored.

•When storing is complete, “Storing complete. Auto Setup is now finished.” is displayed on the on-screen display.

wSelect “Exit”, then press ENTER.

eDisconnect the setup microphone from the AVR-1909.

nTo cancel storing

Press ui to select “Cancel 0”, then press o.

• All the measured auto setup data will be erased.

NOTE

Do not turn the power off while the settings are being stored.

ENGLISH

Error Messages

Getting

If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is

displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure over

Started

again.

Connections

Error messages (examples)

Cause

Measures

Microphone:None

• Not all speakers could be detected.

• Check the speaker connections.

Auto Setup

• Included setup microphone is not connected.

• Connect the included setup microphone to the SETUP

Audyssey

MultEQ

MIC jack on the main unit.

Caution!

or

• The

front

L speaker

was

not

properly

Setup

Speaker

:None

detected.

Retry

• Too

much

noise in

the

room

for

accurate

• Either turn off any device generating noise or move it

Playback

Cancel

Auto Setup

measurements to be made.

away.

Audyssey MultEQ

Remote

Caution!

• Try again when the surroundings are quieter.

Ambient noise is

• Speaker or subwoofer sound is too low for

• Check the speaker installation and the direction

in

too high or

Level is too low.

accurate measurements to be made.

which the speakers are facing.

Control

• Adjust the subwoofer’s volume.

Retry

Cancel

Multi

• Displayed speaker could not be detected.

• Check the connections of the displayed speaker.

· The front R speaker were not properly

-

Auto Setup

zone

Audyssey MultEQ

detected.

Caution!

· Only one channel of the surround speakers

Information

Retry

Front

was detected.

· Sound was output from the R channel

R :None

when only one surround back speaker was

Cancel

connected.

· The surround back, but the surround speaker

Troubleshooting

was not detected.

Auto Setup

• Displayed

speaker

connected with the

• Check the polarities of the displayed speaker.

be

Audyssey MultEQ

polarities reversed.

• For some speakers, this error message may

Caution!

displayed even if the speaker is properly connected. If

Front

you are sure that the wiring is correct, select “Skip”.

Specifications

L :Phase

Retry

Cancel

Skip

Select “Retry” to measure again.

NOTE Be sure to turn the power off before checking the speaker connections.

28