Quick Select Function

With this function, the currently playing input source, input mode, surround mode, MultEQ settings and volume can be stored in the memory.

1Set the input source, surround mode, MultEQ, Dynamic EQ, Dynamic Volume, Front Speaker settings and volume to the conditions you want to store.

2Press and hold the desired QUICK SELECT until “Memory” appears on the display.

The current settings will be memorized.

Last Function Memory

This stores the settings as they were directly before the standby mode was set.

When the power is turned back on, the settings are restored to as they were directly before the standby mode was set.

Backup Memory

The various settings are backed up for about 1 week, even if the power is turned off or the power cord is disconnected.

ENGLISH

Setup Connections Started Getting

[Quick Select Defaults]

 

Input Source

Volume

Quick Select 1

DVD

–40 dB

Quick Select 2

TV/CBL

–40 dB

Quick Select 3

VCR

–40 dB

To call out the settings, press QUICK SELECT at which the desired settings were stored.

The Quick Select name can be changed (vpage 36).

NOTE

Input sources stored with the quick select function cannot be selected if they have been deleted at menu “Manual Setup” – “Option Setup” – “Source Delete” (vpage 36). In this case, store them again.

Personal Memory Plus Function

This function sets the settings (input mode, surround mode, HDMI output mode, MultEQ, Dynamic EQ, Dynamic Volume, audio delay etc.) last selected for the individual input sources.

When you switch to an input source, the settings are automatically set to the ones that were set the last time that input source was used.

The surround parameters, tone settings and the volumes of the different speakers are stored for the individual surround modes.

Resetting the Microprocessor

Perform this procedure if the display is abnormal or if operations cannot be performed.

When the microprocessor is reset, all the settings are reset to their default values.

1Turn off the power using <POWER>.

2Press <POWER> while simultaneously pressing

<INPUT MODE> and <SPEAKERS>.

3Once the display starts flashing at intervals of about 1 second, release the two buttons.

If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.

Specifications Troubleshooting Information zone-Multi Control Remote Playback

64