ENGLISH

Getting

Symbols used to indicate buttons in this manual

Button located on both the main unit and the remote control

Started

unit

BUTTON

Button only on the main unit

<BUTTON>

Button only on the remote control unit

[BUTTON]

Connections

<SOURCE SELECT> <STATUS>

ui

 

 

 

Setup

 

 

 

Playback

 

 

 

Remote

 

 

 

Control

<ON/STANDBY>

ENTER, op

 

 

 

-Multi

[Front]

[OFF]

 

 

[iPod]

 

zone

 

 

 

 

 

Information

 

[1]

[2]

 

 

 

[6, 7]

 

Troubleshooting

 

 

[8, 9]

ENTER

 

 

 

uiop

 

 

 

 

Searching Categories

1Press o p.

SR001

Hits

1

Channel category

CAT :

Pops

 

 

2Use opto select the category, then use uito select the desired station.

•“UPDATING” is displayed while the encording code is being updated.

•“SIRIUS UPDATING” is displayed when updating SIRIUS tuner firmware.

•Refer to “Troubleshooting” – “SIRIUS Satellite Radio” regarding other messages (vpage 85).

Parental Lock

1Tune to the channel you want to lock.

2Press ENTER for at least 3 seconds. “Code: [ ]” is displayed.

3Enter the 4-digit lock code using uio p.

When you enter the correct code, the corresponding channel is locked.

4Press ENTER.

iPod® Playback

The music on an iPod can be played by using the control dock for iPod (ASD-1R, ASD-3N or ASD-3W sold separately).

The operation can also be performed using the buttons on the main unit or remote control unit while watching the menus.

iPod is a trademark of Apple Inc., registered in the U.S.

and other countries.

b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally permitted for your private use as an individual. Be sure to comply with applicable copyright legislation.

Basic Operation

1Make the necessary preparations.

qSet the iPod in the DENON control dock for iPod.

(vSee the control dock for iPod’s operating instructions.) wAssign the control dock for iPod’s input.

The input for the control dock for iPod is assigned to VCR by default.

MENU : ”Input Setup” – “Assign” – ”iPod dock”

(vpage 42)

2Either turn <SOURCE SELECT> or press [iPod] to select the input source assigned in step 1-wabove.

Specifications

[SOURCE

[SOURCE

CONTROL 1]

CONTROL 2]

[Rear]

 

 

[iPod]

 

 

[TUNING+/–]

 

 

[MODE]

uiop

 

 

 

 

ENTER

•Channels under Parental Lock cannot be tuned in by performing Tuning Up/Down or by category search.

•Channels stored in preset memory can be tuned in by the preset channel select operation, even if Parental Lock is applied.

•When a channel to which Parental Lock is applied is being played, Parental Lock for that channel is cancelled by performing Step2.

•See “Edit Lock Cord” (vpage 43) for the method of changing Parental Lock Cord.

•You can also set “Parental Lock” from the menu (vpage 43).

OK to disconnect.

(iPod screen)

bIf the screens above are not displayed, the iPod may not be properly connected. Try connecting again.

3Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2] to “iPod/NETWORK”.

(vpage 65 “Remote Control Unit Operations”)

59