Denon AVR-1911 o p, Step, Step, NOTE, NOTE, ENTER, ENTER, ENTER, ENGLISH, microphone to, 7 press ENTER, Move the setup, Setup over again, and then press ENTER

ENGLISH

Set up speakers (Audyssey® Auto Setup)

Preparation	Step 1						Step 2
	Speaker Detection						Measurement
Connect the setup microphone to the	• In step 1, you will perform measurements at the main listening position.						• In step 2, you will perform measurements at
	• This step automatically checks the speaker configuration and speaker size, and calculates the channel						multiple positions (two to six positions) other than
4 SETUP MIC jack of this unit.	level, distance, and crossover frequency. It also corrects distortion in the listening area.						the main listening position.
	6 The detected speakers are displayed.		If “Caution” is displayed:				• You can achieve a more effective correction of
							measurements at multiple positions.
			NOTE				distortion within the listening area by performing
		MultEQ	Go to “Error messages” (vpage 10), check				Move the setup	microphone to
			any related items,	and perform the necessary
	Step1:Speaker Detection						8 position 2, use ui to select “Next”,
	Front Sp.	:Yes	procedures.
	Center Sp.	:Yes	If the problem is	resolved, return and	restart
When the setup microphone is	Subwoofer	:Yes	“Audyssey Auto Setup”.				and then press ENTER.
	Surround Sp.	:Yes					The measurement of	the second position
connected, the following screen is
	Next		When performing Audyssey Auto				starts. Measurements can be made in up to
displayed.
	Retry		Setup over again				six positions.
3-1.Audyssey Auto Setup	[ENT]:Next						Step2:Measurement
			Press ui to select “Retry”, and then		press
MultEQ								MultEQ
Please place microphone	NOTE		ENTER.				Please place microphone
at ear height at							at ear height at
main listening position.	If a connected speaker is not displayed, the		When measuring has stopped				2nd listening position.
Amp Assign:	speaker may not be connected correctly. Check						Next
ZONE2	the speaker connection.		q Press ui to select “Cancel”, then press				Calculate
Start			ENTER.				Cancel
Cancel	Use ui to select “Next” and then						[ENT]:Next
			w Press o p to select “Yes”, then press ENTER.
[ENT]:Select [RTN]:Back	7 press ENTER.
Here, we explain setup using the example of			Setting up the speakers again
5.1-channel speaker playback.							If you want to omit measurements from the next
For settings other than 5.1-channel surround,			Repeat the operation from step 4 of Preparation			.
							position onward, select “Calculate”.
select “Amp Assign” and perform steps 3 to 4 of
							(Go to Step 3 Calculating	)
“Set up speakers” (vpage 35).

5 Use ui to select “Start” and then press ENTER.

When measuring begins, a test tone is output from each speaker.

• Measurement requires several minutes.

If “Cancel” is selected

“Cancel Auto Setup?” is displayed on the TV screen. If “Yes” is selected, “Audyssey Auto Setup” closes.

9 Repeatto 6. step 8, measuring positions 3

When measurement of position 6 is completed, a “All the measurements were finished.” message is displayed.

Step2:Measurement

MultEQ

All the measurements were finished.

Calculate

Retry

Cancel

[ENT]:Calculate

8	Remote control operation	Move the cursor	Confirm the setting	Return to previous menu
	buttons	(Up/Down/Left/Right)