ENGLISH

Before setting up the system

1

Refer to “CONNECTIONS” (pages 7 to 15) and check that all connections are correct.

2

ON OFF

Press the Power switch (button) .

 

• ¢ ON

The power turns on and indicator is light.

Set the power switch to this position to turn the power on and off from the included remote control unit.

(Main unit)

• £ OFF

The power turns off and indicator is off.

 

 

In this position, the power cannot be turned on and off from the remote control unit.

3

ON / STANDBY

Turn on the power.

Press the Power ON/STANDBY switch (button).

(Main unit)

(Remote control unit)

4

5

Press the SYSTEM SETUP button to enter the setting.

*SYSTEM SET UP

NOTE: Please make sure the “AUDIO” position of the slide switch on the remote control unit.

Press the ENTER or (down) button to switch to the Auto Setup.

NOTE:

Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at any time. The changes to the settings made up to that point are entered.

Auto setup

The Auto Setup function of this unit performs an analysis of the speaker system to permit an appropriate automatic setting.

When performing Auto Setup, an optional microphone is required for the setup.

2Measurement and setting details

q: This sets the speaker connection mode, polarity, and bass reproduction ability.

w: This sets the optimum delay time from each speaker corresponding to the listening position. e : This sets the volume that is output from each speaker.

NOTE:

•A loud test tone is output during the measurement. Please consider this should you be planning night time measurements, and consider not allowing small children into the listening room at this time.

21