ENGLISH

Recalling preset stations

1 2

1

Watching the display, press the SHIFT button to select the

 

 

preset memory block.

 

 

 

SHIFT

 

 

 

(Main unit)

(Remote control unit)

 

 

NOTE: Please make sure the “AUDIO” position of the slide

 

2

switch on the remote control unit.

 

Watching the display, press the PRESET • (+) or ª (–) button

 

 

 

 

to select the desired preset channel.

 

 

2

 

 

 

1

ª PRESET •

 

 

 

 

 

 

(Main unit)

(Remote control unit)

15LAST FUNCTION MEMORY

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

•The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit’s power switch is off and with the power cord disconnected.

16INITIALIZATION OF THE MICROPROCESSOR (RESET)

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure.

1 Switch off the unit using the main unit’s power switch.

2

Hold the following SPEAKER A button and B button, and turn

 

 

 

 

the main unit’s power switch.

 

 

 

3

Check that the entire display is flashing with an interval of

 

 

 

 

about 1 second, and release your fingers from the 2 buttons

 

 

and the microprocessor will be initialized.

1, 2

2

NOTES:

•If step 3 does not work, start over from step 1.

•If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment from the factory).

64