ENGLISH
Connecting the microphone for Auto Setup
1 | Connect the microphone for Auto Setup to the Setup Mic | |||||
connector on the front panel of the unit. |
| |||||
| PHONES | SPEAKER | SURROUND | 5CH / 7CH DIRECT / | SURROUND SELECT | TONE |
| MODE | CONTROL | ||||
| A | B | BACK | STANDARD STEREO STEREO | V.AUX INPUT |
|
|
|
|
|
| SURROUND | TONE |
|
|
|
|
| PARAMETER | DEFEAT |
|
|
|
| VIDEO L AUDIO R OPTICAL SETUP |
|
AV SURROUND RECEIVER
Listening position
2 | Place the microphone for Auto Setup at the actual listening |
position which will be at the same height as your ears. Use a |
tripod or level surface at positioning.
Setting the Auto Setup
1 | • Use the | (left) button to switch the Auto Setup mode. |
|
• Press the ENTER or (down) button to switch to the speaker configuration set up.
1 AutoSet <YES
2 | Check the “Power Amp Assign” setting. | |
• | When “Surround Back” is selected, the test tone during Auto Setup will be output from the Surround Back speaker. | |
| • | When “ZONE2” is selected, change the setting to “ZONE2” The test tone during Auto Setup is set so that it will not be output to |
|
| ZONE2 (Another room). |
qSelect the Power Amp Assign setting.
wSelect “Surround Back” or “ZONE2”.
(Remote control unit)
AutoSet | SB > |
|
|
(Remote control unit)
NOTE:
•When “ZONE2” is selected at System Setup Menu “Power Amp Assign”, surround back speaker is not displayed.
3 | q Select the “Start”. |
|
|
| w Press the | (left) button to start Auto Setup. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(Remote control unit) | (Remote control unit) |
AutoSet <Start
22