1 BEFORE USING

Pay attention to the following before using this unit:

•Moving the set

To prevent short circuits or damaged wires in the connection cords, always unplug the power cord and disconnect the connection cords between all other audio components when moving the set.

•Before turning the power switch on

Check once again that all connections are proper and that there are not problems with the connection cords. Always set the power switch to the standby position before connecting and disconnecting connection cords.

•Store this instructions in a safe place.

After reading, store this instructions along with the warranty in a safe place.

ENGLISH

•Note that the illustrations in this instructions may differ from the actual set for explanation purposes.

•V. AUX terminal

The AVR-2105/885’s front

panel is equipped with a V.

SURROUND ￿

SELECT TONE ￿

 

MODE

CONTROL

AUX terminal. Remove the

V.AUX INPUT

 

S-VIDEO VIDEO L AUDIO R OPTICAL SETUP MIC

TONE￿

 

SURROUND￿

cap covering the terminal

PARAMETER

DEFEAT

 

AV SURROUND RECEIVER AVR-2105

when you want to use it.

 

 

2 CAUTIONS ON INSTALLATION

Noise or disturbance of the picture may be generated if this unit or any other electronic equipment using microprocessors is used near a tuner or TV.

If this happens, take the following steps:

•Install this unit as far as possible from the tuner or TV.

•Set the antenna wires from the tuner or TV away from this unit’s power cord and input/output connection cords.

•Noise or disturbance tends to occur particularly when using indoor antennas or 300 Ω/ohms feeder wires. We recommend using outdoor antennas and 75 Ω/ohms coaxial cables.

For heat dispersal, leave at least 4 inch/10 cm of space between the top, back and sides of this unit and the wall or other components.

3 CAUTIONS ON HANDLING

4 inch/10 cm or more

4 inch/10 cm or more

Wall

•Switching the input function when input jacks are not connected

A clicking noise may be produced if the input function is switched when nothing is connected to the input jacks. If this happens, either turn down the MASTER VOLUME control or connect components to the input jacks.

•Muting of PRE OUT jacks, HEADPHONE jack and SPEAKER terminals

The PRE OUT jacks, HEADPHONE jack and SPEAKER terminals include a muting circuit. Because of this, the output signals are greatly reduced for several seconds after the power switch is turned on or input function, surround mode or any other-set-up is changed. If the volume is turned up during this time, the output will be very high after the muting circuit stops functioning. Always wait until the muting circuit turns off before adjusting the volume.

•Whenever the unit is in the STANDBY state, the apparatus is still connected on AC line voltage.

Please be sure to turn the power off (£off) when you leave home for, say, a vacation.

5