3

Select the play mode.

 

 

 

Press the SURROUND MODE button, then turn the SELECT

 

 

knob.

 

 

 

 

Example: Stereo

 

 

 

 

SURROUND ￿

 

 

 

 

MODE

 

SELECT

 

 

(Main unit)

 

 

(Remote control unit)

 

To select the surround mode while

SURROUND ￿

 

adjusting the surround

parameters,

MODE

 

 

 

tone defeat or tone control, press

 

 

the surround mode button then

 

 

operate the selector.

 

 

(Main unit)

4

 

 

 

Start playback on the selected component.

 

 

 

 

• For operating instructions, refer to the component’s manual.

5

Adjust the volume.

 

 

 

 

 

MASTER VOLUME

 

 

The volume level is

 

 

 

 

displayed on the

 

 

 

 

master volume level

(Main unit)

(Remote control unit)

 

display.

 

 

 

 

The volume can be adjusted within the range of –70 to 0 to 18 dB, in steps of 0.5 dB. However, when the channel level is set as described on page 48, if the volume for any channel is set at +0.5 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume is adjusted to “18 dB — (Maximum value of channel level)”.)

Input mode when playing DTS sources

•Noise will be output if DTS-compatible CDs or LDs are played in the “ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to “DTS”.

ENGLISH

Input mode display

• In the AUTO mode

One of these lights, depending on the

input signal.

INPUT

AUTO PCM DTS

DIGITAL ANALOG

• In the DIGITAL PCM mode

INPUT

AUTO PCM DTS

DIGITAL

• In the DIGITAL DTS mode

INPUT

AUTO PCM DTS

DIGITAL

• In the ANALOG mode

INPUT

AUTO PCM DTS

ANALOG

Input signal display

• DOLBY DIGITAL

SIGNAL

DIGITAL

• DTS

SIGNAL

DIGITAL

• PCM

SIGNAL

DIGITAL

The DIGITAL indicator lights when digital signals are being input

properly. If the DIGITAL indicator does not light, check whether

the digital input component setup (page 29) and connections are

correct and whether the component’s power is turned on.

NOTE:

•The DIGITAL indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard.

41