3

Select the play mode.

Example: Stereo

SELECT

(Remote control unit)

(Main unit)

To select the surround mode while adjusting the surround parameters, channel volume or tone control, press the surround mode button then operate the selector.

4

 

 

(Main unit)

Start playback on the selected component.

 

 

• For operating instructions, refer to the component’s

 

manual.

 

 

5

Adjust the volume.

 

MASTER VOLUME

 

The volume level is

 

 

 

displayed on the

(Remote control unit)

(Main unit)

 

master volume level

 

 

 

display.

 

 

The volume can be adjusted within the range of –80 to 0 to 18 dB, in steps of 0.5 dB. However, when the channel level is set as described on page 32~34 or pages 68 and 69 if the volume for any channel is set at +0.5 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume adjustment range is “18 dB — (Maximum value of channel level)”.)

Input mode when playing DTS sources

•Noise will be output if DTS-compatible CDs or LDs are played in the “ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to “DTS”.

Input mode display

Depending on the input signal.

• In the AUTO mode

•In the DIGITAL PCM mode

•In the DIGITAL DTS mode

•In the ANALOG mode

•In the EXT.IN mode

Input signal display

•DOLBY DIGITAL

•DTS

•PCM

The DIG. indicator lights when digital signals are being input properly. If the DIG. indicator does not light, check whether the

digital input component setup (page 37) and connections are

correct and whether the component’s power is turned on.

AL24 processing is activated when PCM signals are played while the surround mode is set to PURE DIRECT, DIRECT, STEREO.

NOTE:

•The DIG. indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard.

60