4

Start playback on the selected component.

• For operating instructions, refer to the component’s

manual.

 

 

 

5

Either turn the MASTER VOLUME dial on the main unit or

use the VOLUME buttons on the remote control unit to

adjust the volume.

 

 

 

 

DIGITAL DVD

The volume level is

 

displayed on the

 

 

 

 

display.

 

 

+

 

 

-

Input mode display

• In the AUTO mode

Lit

•In the DIGITAL PCM mode

•In the DIGITAL DTS mode

•In the ANALOG mode

ENGLIS

One of these lights, depending on the input signal.

Main unit

Remote control unit

•The volume can be adjusted within the range 0 to 60. Note that depending on the input signal, surround mode, speaker settings and channel level setting, it may not be possible to adjust the volume up to 60.

2To check the currently playing program source, etc. Press the MENU/SET button. Display “STATUS” then press the select 0 and 1 control.

Main unit

Main unit

The current program source and surround settings are shown on the display each time the button is pressed or turned.

Input signal display

•DOLBY DIGITAL

•DTS

•PCM

•“DIG” lights when digital signals are input properly. If “DIG” is flashing, check whether the connections are proper and whether the input component’s power is on.

Input mode when playing CD sources

•When playing CDs containing recordings of live concerts, etc., in the “AUTO” mode, the sound may be slightly broken at the beginning. If this happens, switch to the “PCM” mode.

Input mode when playing DTS sources

•If DTS-compatible CDs are played in the “PCM” mode, noise is output because DTS playback is not possible.

To play a DTS-compatible source, be sure to set the input mode to “AUTO” or “DTS”.

•Noise may be generated at the beginning of playback and while searching during DTS playback in the AUTO mode. If so, play in the DTS mode.

31