OWNER’S MANUAL
INSTALLATION | Optional Wall Switch | |
Note: This unit does | ||
Continued | ||
not have a HI/LOW | ||
| ||
| feature | |
Gas Valve | To | |
| Thermopile |
|
| O |
| |
|
| IL | T |
|
|
| P |
|
|
| N | 16AI |
|
|
| O |
|
| |
O | T |
|
| TH |
|
|
| ||
L |
| 7 | ||
I |
| |||
P |
|
|
| |
| FFO |
|
| TP |
|
|
|
|
Plastic
ReceiverMounting
Clips
Mounting
Bracket
Figure 36 - Installing Remote Receiver (Shown from Rear of Mounting Bracket)
E | TPTH |
A |
Route Millivolt Wires (Supplied) | (Back View) | |
Through Gas Line Conduit Sleeve | ||
|
Figure 34 - Wall Switch Wiring Diagram
Note: If any of the original wire supplied must be replaced, use type 18
Battery Clip
Terminal Wires
Receiver
Figure 37 - Installing Battery in Receiver
ELECTRICAL HOOKUP FOR BLOWER ACCESSORY
Before blower accessory can be operated, it must be properly connected to a standard 120 VAC power source. Refer to Wiring Diagram on page 20.
An outlet box with two receptacles has been supplied for your convenience, located on the lower left side of the appliance (see Figure 35).
WIRELESS
Note: If using the wireless
NOTICE: Only use alkaline bat- teries (not included, requires 2).
Installing
1.Remove battery cover on back of re- mote control unit.
2.Attach terminal wires to the battery (not included). Place battery into the battery housing.
3.Replace battery cover onto remote con- trol unit.
CAUTION: Due to high tem- peratures, make sure no wires are touching the bottom of the firebox.
From Blower
Assembly
Figure 35 - Connecting Blower Accessory to Power Supply
Installing Receiver
Note: Receiver is preinstalled.
1.Remove access panel from lower front face of firebox. Lift straight up on ac- cess panel until it stops. Pull bottom of access panel forward, then down.
2.Disconnect wall switch wires from TH and TPTH terminals on control valve (see Figure 34).
3.Install remote receiver unit onto mount- ing bracket using the two plastic mount- ing clips (see Figure 36).
4.Connect wires to control valve. Con- nect white wire to terminal TH. Con- nect red wire to terminal TP/TH.
5.Locate the battery clip mounted on the back of the receiver (see Figure 37).
6.Slide
7.Attach the terminal wires to the battery (see Figure 37).
8.Replace access panel. Place top of ac- cess panel into opening and slide up. Push bottom of access panel in and slide down to install.
Battery
Cover Remote
TerminalControl Unit Wires
Battery
Housing
Figure 38 - Installing Battery in Hand- Held Remote Control Unit
Continued
106442 | 15 |