Desa RFP28TB installation manual Pre-Drilled Hole Screw Hearth Base Accessory Wood Plug

INSTALLATION

Continued

2.Locate pre-drilled holes at bottom of each side of mantel (see Figure 23). Use an electric drill with 1/8" drill bit. Insert drill bit into pre-drilled holes in mantel and drill through heater hearth base. Make sure the drill bit does not damage any gas plumbing lines inside hearth base.

3.Locate two 2" screws from hardware package. Insert screws through pre-drilled holes at bottom of each side of mantel (see Figure 23). Tighten each screw into the heater hearth base. Make sure the screw tips do not damage any gas plumb- ing lines inside hearth base. Note: The pre-drilled holes are countersunk.

Tighten the screws all the way into the holes.

4.Locate two wood plugs from hardware package. Insert plugs into screw holes (see Figure 23). Tap into place.

Pre-Drilled

Hole

2" Screw	Hearth Base
	Accessory
Wood Plug
Figure 23

101935

19