INSTALLING OPTIONAL
CONTROLS
Continued
6.Use clips to mount receiver on remote mount- ing bracket as shown in Figure 16.
Plastic Mounting
Clips
REMOTE ON OFF
Towards Front
Remote Receiver
Figure 16 - Mounting Remote Receiver to
Bracket
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to a
3. Replace battery cover onto remote control unit.
Battery
Cover
Terminal
Wires
Remote | ||
Battery | ||
Control | ||
Battery | ||
Unit | ||
Housing |
Figure 17 - Installing Battery in Hand- Held Control Unit (HRC100 Series)
INSTALLING OPTIONAL WIRELESS REMOTE CONTROL - MODEL WRC (Electronic Ignition)
Installing and Activating the Remote
Receiver
1. Open bottom louver and locate plug recep- tacle. The plug receptacle is located either on the right or left side of cabinet.
2. The WRC model receiver does not require a battery. Receiver can be installed by first plugging short extension cord into fireplace receptacle. Then plug receiver unit into exten- sion cord. Finally plug ignition module plug into receiver unit (see Figure 18).
3. Activate remote handset battery by removing insulating tab on back of handset (see Figure 19). Battery is included preinstalled.
4. Once battery is activated unit is ready to use.
5. Replace bottom louver panel.
Fireplace | Remote |
Receptacle | Control |
| Receiver |
| Ignition |
Extension Cord | Module |
Plug |
Figure 18 - Installing WRC Remote Receiver
Battery Cover
12 Volt Battery Back of Handset
Pull to
Remove
Insulation
Tab
Figure 19 - Installing Battery into Back of
Handset
12 | www.desatech.com |
