Operating Fireplace
Continued
Manual Lighting
Procedure
1.Remove glass door (see Removing/Replacing Glass Door, page 17).
2.Follow steps 1 through 8 under Lighting Instructions, page 19).
3.Press gas control knob and light pilot with match.
4.Keep gas control knob pressed in for30 seconds after lighting pilot.After 30 seconds, release gas control knob. Follow steps 10 through 11 under Lighting Instructions, page 19).
5.Replace glass door (see Removing/Replacing Glass Door, page 17).
Electronic Ignition
System
lighting
instructions
1.STOP! Read the safety information, col- umn 1, page 19.
2.Turn off all electrical power to the fireplace.
3.Turn wall switch to the OFF position.
4.Open lower louver panel.
5.Turn equipment shutoff valve clockwise
to the OFF position (see Figure 34). Do not force.
6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.
If you smell gas, STOP! Follow “B” in the safety information, column 1, page 19. If you don’t smell gas go to the next step.
7.Turn equipment shutoff valve counterclock-
wise to the ON position. Do not force.
8.Close lower louver panel.
9.Turn on all electric power to the fireplace.
10.Turn the wall switch to the ON position.
11.Visually locate the pilot. The ignitor should begin to spark and the main burner should ignite once flame appears at pilot.
•If lighting the appliance for the first time each season, it may take several attempts before the supply gas can reach the pilot and main burner.
•If the appliance will not stay lit after sev- eral attempts, follow the instructions To Turn Off Gas To Appliance, and call your service technician or gas supplier.
NOTICE: During initial operation of a new heater, the burning of residues from the manufacturing process of the firebox and logs
Figure 34 - Turning Equipment Shutoff
Valve to the OFF Position
TO TURN OFF GAS
TO APPLIANCE
1.Turn off the wall switch.
2.Turn off all electric power to the appliance if service is to be performed.
3.Open lower louver panel.
4.Turn equipment shutoff valve clockwise
to OFF. Do not force.
5.Close lower louver panel.
Pilot | Ignitor |
| |
Burner |
|
| Sensor |
| Rod |
Figure 35 - Pilot
OPTIONAL WIRELESS
REMOTE OPERATION
Note: The WRC receiver and
1.Turn equipment shutoff valve to ON posi- tion. You can now turn the burner on and off with the
IMPORTANT: Be sure to press the ON/OFF buttons on the
2.Press the ON/OFF button to turn the burner on and off.
20 | www.desatech.com |