Fireplace Installation
Continued
Removing Louver Panels
Remove the top and bottom louver panels by si- multaneously pulling both top end spring latches towards the center of the appliance until they are disengaged from the locating holes (see Figure 28). Repeat for bottom spring latches and pull the lou- vers outward. To install or replace items removed, simply reverse the procedures above.
Louver
Panel
Spring
Latch
Figure 28 - Removing Louver Panel
Removing/Replacing Glass Door
WARNING: Handle glass door panel with care. Do not strike, slam or otherwise abuse glass. Do not operate fire- place with glass door removed, cracked or broken.
Spring Clips
1. Lift Up Panel
at Lower Rail
Glass Panel
Frame Rail
Figure 29 - Removing/Replacing Glass
Door
Locating
Hole
If replacement of glass is necessary, the entire assembly, glass and frame, must be replaced. If glass is broken, wear gloves and tape the remaining fragments onto the frame.
1. | Placing a screw driver or your finger tips into |
| the gap between lower glass panel rail and |
| bottom face frame, lift glass door assembly |
| until door pins clear locating holes in bottom |
| face frame (see Figure 29). |
2. | Swing bottom glass panel assembly out until |
| door pins on lower rail clear bottom face frame |
2. Swing Out
Panel
3. Lower
Panel Out
Glass Panel
Frame Rail
Door Pin
| (see Figure 30). |
3. | Lower door down until upper door pins are |
| free of locating holes in spring clips and place |
| in a safe area. |
4. | Replace glass panel in reverse order by insert- |
| ing top door pins into spring clips, lifting up |
| at lower frame rail and locating bottom pins |
| in holes on lower face frame. |
Figure 30 - Removing/Replacing Glass
Door
www.desatech.com | 17 |
