
Venting Installation
instructions
Continued
Number | Description |
|
| High Wind Round Horizontal | |
| Termination Kit (Includes Round | |
| Termination, | Wall Firestop, |
| 45° Elbow) |
|
High Wind Round Termination Kit, | ||
| Galvinized |
|
Horizontal Round Termination Kit | ||
| (Includes Round Termination, | |
| Wall Firestop, 45° Elbow) | |
Horizontal Round Termination, | ||
| Galvanized |
|
Horizontal Square Termination, | ||
| Galvanized |
|
| Horizontal Square Termination Kit | |
| (Includes: Square Termination, | |
| Wall Firestop, 45° Elbow) | |
Horizontal Square Termination, | ||
| Galvanized |
|
Vertical Round Termination, | ||
| Galvanized |
|
14" Snorkel | Termination, | |
| Galvanized |
|
36" Snorkel | Termination, | |
| Galvanized |
|
Storm Collar, Galvanized | ||
Wall Firestop, Galvanized | ||
Roof Flashing - 0 to 6/12 Pitch, | ||
| Galvanized |
|
Roof Flashing - 6/12 to 12/12 | ||
| Pitch, Galvanized | |
Vertical Restrictor, Galvanized | ||
V i n y l S i d i n g S t a n d o f f , | ||
| Galvanized |
|
Wall Strap |
| |
Cathedral Ceiling Support | ||
Firestop Plate |
| |
Stucco Flashing - For use | ||
| with |
|
Flat Roof Flashing |
Fireplace
Installation
CHECK GAS TYPE
Use proper gas type for the fireplace unit you are installing. If your gas supply is not correct, do not install fireplace. See retailer where you purchased the fireplace for proper fireplace according to your gas type or to purchase gas conversion kit (see Ac- cessories, page 33).
Installing optional blower accessory
NOTICE: If installing blower in an existing fireplace with gas connections, shut off gas sup- ply and disconnect heater from gas supply. Contact a qualified service person to do this.
WARNING: If there is a duplex electrical outlet installed in the right side of the bottom of the fireplace base area, be sure that theelectricalpowertotheoutletis turned off before proceeding with blower installation. Failure to do this may result in serious injury.
Model BK Installation
Follow all instructions provided in the blower accessory kit.
1.Attach the power cord to the blower motor by firmly pushing the two female terminals at the end of the power cord onto the two spade terminals on the blower motor (see Figure 25).
2.Attach green ground wire from power cord to blower housing using screw provided (see Figure 25). Tighten screws securely.
Side View | Blower | |
Lower Firebox | Location | |
Magnetic | ||
Cavity | ||
Strips | ||
Spade | ||
| ||
Terminals |
| |
Green |
| |
Ground |
| |
Wire |
|
Screw Exhaust
Port
Figure 25 - Blower Model BK
www.desatech.com | 17 |