Wiring Diagram
IGNITOR LEAD
ORANGE
EV1
EV2
PILOT
|
|
| BLUE |
|
E12 |
| SYNETEK CONTROLS | TRANSFORMER |
|
|
|
| ||
| IS1070B | WHITE |
| |
E8 | 24V AC | 120V AC | ||
E6 | ||||
E4 | ||||
E3 | ||||
E2 | ||||
|
| INC | BLACK |
|
|
|
|
| |
|
|
| GROUND |
|
|
|
| RED |
|
GREEN |
|
|
|
|
Operating Fireplace
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.
A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch.
•Do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation of new heater, burning logs will give off a
1.STOP! Read the safety information.
2.Turn off all electric power to the appliance.
3.Turn wall switch to the OFF position.
4.Open lower louver panel.
5.Turn equipment shutoff valve clockwise 
to the OFF position (see Figure 48, page 27). Do not force.
6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.
If you smell gas, STOP! Follow “B” in the safety information in column 1. If you don’t smell gas, go to the next step.
26 | www.desatech.com |
