Fireplace
Installation
Continued
8.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto the exposed section of the front burner and along the space between the burner and grate prongs (see Figure 45). This will create the glowing ember appearance as the flame touches the ember material. Do not block air slots by using too much ember material in one area. It is not necessary to use all of the ember material provided.
9.Close glass door, lock door latches, replace screen and close louvers (see steps 5 and 7 of
Removing/Replacing Glass Door, page 20).
4 
Figure 43 - Installing Log No. 4
6
5
Figure 44 - Installing Logs No. 5 and No. 6
Ember Material
Figure 45 - Placing Ember Material on
Burner
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to ac- tivate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wiring that supplies the electricity to the fireplace.
optional Remote control INSTALLATION (model WRC)
Note: If using optional wireless
1.Open lower louver panel.
2.The WRC model receiver does not require a battery. The receiver can be installed by first plugging the short extension cord into the fireplace receptacle. Then plug the receiver unit into the extension cord. Finally plug the ignition module plug into the receiver unit (see Figure 46).
3.Activate the remote handset battery by removing the insulating tab on the back of the handset (see Figure 47). The battery is included
4.Once the battery is activated the unit is ready to use.
5.Close lower louver panel.
Fireplace | Remote | |
Control | ||
Receptacle | ||
Receiver | ||
|
| Ignition Module |
Extension Cord | Plug |
|
Figure 46 - Installing the WRC Remote
Receiver
Battery Cover
12 Volt Battery
Back of | Pull to Remove |
Handset | Insulation Tab |
Figure 47 - Installing Battery into Back
of Handset
www.desatech.com | 25 |
