![](/images/new-backgrounds/1214214/21421423x1.webp)
2. Fig. 18 illustrates fence properly mounted.
3.Thread shorter fence handle (E ) Fig.19, into infeed end of fence (A) and longer fence handle (G) into outfeed end as shown.
ASSEMBLING CUTTERHEAD GUARD
1.Remove set screw (not shown) from cutterhead guard post (F) with the 2.5mm hex wrench. Insert post
(F) through hole in the infeed table. NOTE: A spring is supplied in knob assembly (E) that returns the guard (C) over the cutterhead after a cut has been made. Turn knob (E)
2.Thread set screw (B) Fig. 21 back into post (F) Fig. 20, to keep cutterhead guard (C) in position during jointer operation.
3.Fig. 21, illustrates the cutterhead guard (C) assembled to the infeed table.
Fig. 18
G
E
A
Fig. 19
C
F
E
Fig. 20
C
B
Fig. 21
12