X10 button once to increment it to 250ns, then rotate the encoder wheel to increase it to 300ns. At this point, pressing the X10 button again would increase the delay to 3.00us, pressing it again increments it to 30.0us, etc.
An additional function is that if it is held while changing ANY frequency value, after multiplying the value by a factor of ten, if the encoder is moved it will increase/decrease at a much faster rate. This makes the switching frequency much quicker and easier.
PW/PRF Button
This is for varying the parameters Frequency and Pulse Width and toggling between the two settings quickly. If you are in any menu that is not a CHANNEL MENU, it will flip you immediately to the CHANNEL 1 menu and the FREQUENCY setting.
Out 1 and Out 2
These are the pulse output connectors. The outputs of the
Sync Out
This is a 5V signal into 1
Trigger In
This is an input signal into 1KOhms used for external Pulse Repetition Frequency (PRF) triggering. It is designed to allow the user to trigger multiple
Power LED
Indicates that the power switch on the rear of the unit is in the ‘on’ position and that AC power is applied to the unit.
Front Panel Controls & Connections
AC Power Entry Module
The driver is grounded through the grounding conductor of the AC power cord. To avoid electrical shock, plug the driver into a properly wired receptacle before making connection to any input or output connectors. Use only a power cord that is in good condition.
Page 3
© 2004 Directed Energy, Inc.
