Directed Electronics PDG-2515/2520 manual PDG-2515 Operating Manual Quick Start Guide

PDG-2515/2520 Operating Manual

PDG-2515 Operating Manual

Quick Start Guide

This quick-start guide provides a step-by-step guide to manually operating the PDG-2515. Please refer to the appropriate sections of the manual for additional instructions and guidelines. The SAFETY warnings in the manual must be read and understood prior to operating the PDG-2515.

What’s In The Box?

1ea. PDG-2515 Digital Delay & Pulse Generator 1ea. Power Cord

2ea. 50 Ohm Coaxial Output Cable 1ea. Operating Manual

Unpacking

Carefully remove each component listed above. Your PDG-2515 and accessories were inspected at the factory prior to shipment. Inspect the PDG- 2515, power cord and output cables for signs of shipping damage. If any damage is noted contact the factory prior to operating the equipment.

Setup

Connect OUT1 and/or OUT2 to an appropriate load using 50 Ohm coaxial cable (included).

Plug the AC power cord into the rear power entry module of the PDG-2515, and into an appropriate AC socket.

Power Up

Turn on the PDG-2515 by pressing the power button located above the power entry module in the rear of the unit.

The front panel display will read initialize and display the software and hardware versions internal to the unit on the front panel. After a few moments the unit will finish initialization and the first screen/menu that will appear is the menu for CHANNEL 1. Note: The buttons and encoder on the front panel will have no effect as the unit comes up from initialization.

Front Panel Controls & Connections

Encoder

This is for varying the parameters such as Frequency, Pulse Width, Delay, Trigger Source, etc.

Page 1

MNPDG2515-2520R0.doc

© 2004 Directed Energy, Inc.